Product Overview

Our 40ft expandable container house is the largest unit in our double-wing modular range. It is fully assembled, insulated and finished in our factory before shipment, and folds down to container width for transport.
Folded, the house is 11800 mm long and only 2.2 m wide, so one complete unit takes one 40HQ container. On arrival the two side wings are opened outwards 2.05 m on each side and locked, turning the 2.2 m transport width into a 6.3 m floor width. The finished house measures 11.8 × 6.3 × 2.48 m outside, giving 74.34 ㎡ of floor area under one roof.
The plan is arranged in three bands. The front band carries the entrance, an open living and dining room and a kitchen at one end. The central band is the access corridor, with the bathroom and a laundry corner off it. The rear band holds three rooms of 3650, 3880 and 3630 mm width, each 2050 mm deep, every one of them with a window on the rear wall.
All doors, windows, wiring, plumbing and drainage are pre-installed at the factory. A four-person team unfolds and locks the house in two to three hours; no heavy construction is required on site, and the unit can be folded again and moved to a second plot.
The structure is a Q235B hot-dip galvanized steel frame with 50/75 mm sandwich panel walls, 220 mm external wall thickness for cold and wet climates, and wood-grain decorative metal cladding on the elevations.
Key Features
- 74 ㎡ in One 40HQ. A full 11.8 m house fits a standard 40HQ when folded. Freight per square metre is the lowest in our range, and no open-top or flat-rack booking is needed.
- Three Rooms Plus Open Living. Two bedrooms and a third room for bunks, storage or a study, all opening off one corridor; living, dining and kitchen run as a single open band along the front.
- Two to Three Hours to Install. Both wings unfold and lock in 2–3 hours with four workers. No concrete foundation mandatory; ground beams or pads are sufficient.
- Deeper Insulation for Cold Climates. 220 mm external walls with 50/75 mm sandwich panels - EPS, rockwool or PU - keep the house warm in winter and quiet at night. A2 rockwool available.
- Full Factory Pre-finish. Pre-wired, pre-plumbed, kitchen block, sanitary ware and windows fitted before shipment. Ready to occupy once water and power are connected.
- Robust Steel Frame. Q235B hot-dip galvanized frame with anti-rust coating and a service life over 30 years; corner castings allow crane lifting and repeated transport.
- Foldable and Relocatable. The wings fold back to 2.2 m width, so the house can be unbolted, lifted and shipped to a second site instead of being abandoned.
- Wide Application. Small home, beach cabin, holiday rental, worker housing, farm accommodation, site office or emergency shelter.
Specification
|
Item |
Specification |
|
Model |
40ft Expandable Container House (double-wing) |
|
Folded Size |
Floor Plan & Layout11800 × 2200 × 2480 mm |
|
Expanded Overall Size |
11.8 × 6.3 × 2.48 m (11800 × 6300 × 2480 mm) |
|
Internal Clear Length |
11360 mm |
|
Total Floor Area |
74.34 ㎡ |
|
Layout |
Open living-dining-kitchen; 3 rooms and bathroom off a central corridor |
|
Main Frame |
Q235B hot-dip galvanized steel frame |
|
Wall Panel |
50/75 mm sandwich panel (EPS / rockwool / PU optional), 220 mm external wall |
|
Exterior Cladding |
Wood-grain decorative metal siding (as shown) |
|
Door |
Aluminium double-glass entrance door |
|
Window |
Aluminium casement window with tempered double glazing |
|
Floor |
MGO board / SPC vinyl floor / PVC floor optional |
|
Weight |
5.6–6.8 t |
|
Loading |
1 set per 40HQ container |
|
Installation Time |
2–3 hours (4 workers) |
Floor Plan & Layout
The external envelope is 11800 × 6300 mm with 220 mm walls and a 11360 mm clear internal length; internal partitions are 50 mm panels. Heat loss and sound transfer are handled at the envelope, so partitions stay thin and floor area is not wasted.
Front band, 2050 mm deep. The entrance door opens onto the living and dining area, which runs the length of the house. At one end sits a desk and chair corner; at the other end the kitchen block with sink, hob and fridge space, plus a laundry corner with washer connection.
Central band, 2200 mm deep. This is the corridor linking the front band to the sleeping rooms, with the bathroom at one end - WC, basin, shower and extractor - and a storage run along the party wall.
Rear band, 2050 mm deep. Three rooms of 3650, 3880 and 3630 mm clear width, each with a window to the rear elevation. The two-bedroom layout merges the middle room into the master suite; the three-room layout keeps it as a bunk room, study or store.
Partition positions, door swings, the kitchen block and the sanitary layout can all be adjusted at design stage. Wall thickness, cladding colour and glazing are fixed at order, not on site.

Shipping & Loading
Loading: 1 set per 40HQ. The unit is folded and wing-locked before loading and placed lengthwise on the container floor - 11.8 m of the 12.03 m internal length, leaving roughly 0.2 m at the door end.
Because the folded unit uses almost the whole container length, accessories travel inside the folded wings and in the door-end gap: bolts, sealant, pipe fittings, installation tools and the wing-locking hardware, packed in a wooden crate. The unit is secured with timber bracing and steel lashing belts. No stacking.
A packing list and an installation drawing are issued with the CI & PL for customs clearance.
Optional Upgrades
- Solar power system pre-installation. Panels, inverter and battery space reserved at factory stage.
- Rockwool fireproof panels. A2 fire rating for accommodation and worker-housing projects.
- Broken-bridge aluminium windows and doors. Better thermal performance for cold climates.
- External awning or terrace canopy. Shade over the entrance side.
- Waste water tank and septic system kit. For plots without a mains sewer connection.
- Complete furniture package. Beds, wardrobe, sofa, dining table and chairs.
- Smart lighting and water control system. App-controlled lighting, water heater and pump.
- Custom paint colour. Frame and cladding finished to your brand or site palette.
- Stainless steel kitchen unit and sanitary package. Sink, hob, WC and shower delivered with the house.
- Extra window or skylight. Additional opening on the corridor or kitchen side.
FAQs
Q1: Do I need a concrete foundation?
A: Not mandatory. Compacted gravel with ground beams or concrete pads is enough for a single-storey unit. Local building code to be checked by the buyer.
Q2: Is a crane required on site?
A: Only for lifting the unit off the truck and onto the prepared base. A 25 t crane or a telehandler is sufficient; the unit weighs about 6 t.
Q3: How long is production lead time?
A: Normally 20–30 working days after deposit received, depending on panel type, glazing and interior options.
Q4: Can the house be moved after installation?
A: Yes. The wings are folded back to 2.2 m width, the unit is lifted and shipped to the new site for re-installation.
Q5: What certificates can you supply?
A: CE and ISO documentation, SAA certification for the Australian market, plus material and test reports on request.
Q6: Can I customize the layout, colour and interior?
A: Yes. Partition layout, exterior colour, flooring, door style, kitchen and bathroom package are all selectable.
Q7: 40ft or 30ft - which one fits my project?
A: The 40ft gives 74 ㎡ and three rooms on one level, at one unit per 40HQ. The 30ft gives 56 ㎡ and two bedrooms in a shorter body, which suits tighter plots and lower crane reach.
Q8: What power supply does the house use?
A: Standard wiring is single-phase 220–240 V with a 63 A inlet; three-phase or 110 V versions are available on request.
Hot Tags: 40ft expandable container house, China 40ft expandable container house manufacturers, suppliers, factory



